Are trailer jack stands required by OSHA?

While OSHA does not mandate a specific type of jack stand — nor the number or placement of such stands — when stabilizing semi-trailers, the agency says “[f]ixed jacks may be necessary to support a semi-trailer and prevent upending during loading or unloading when the trailer is not coupled to a tractor.”

What are fixed jacks used for?

The term “fixed jacks” can be defined as jacks or what is known in the trade as “nose cones,” the purpose of which is to hold one end of a trailer being worked so as to avoid the possibility of such trailer being “up-ended” in the course of vehicles coming in and out of the trailer.

Where do you jack a semi trailer?

On trailers, position the jack near the end of the axle making sure there is enough room for the support stands between the jack and the tire sidewall.

How does a jack stand work?

Here’s How To Use Your Jack Stands

1. Pull the parking brake.
2. Put wheel chocks around the wheels that will remain on the ground.
3. Locate your jack point and jack up the car.
4. Place your jack stand underneath the car at the designated jack points.
5. Lift or screw the support beam up as close to the contact point as possible.

Can you jack up a trailer on the axle?

It is best to place the jack underneath the axle, and to only jack up the trailer until the trailer’s weight is off the tire. If you need to make any other repairs, place the jack near where you need to work, using the frame or the axles (they are the strongest points underneath the trailer).

What is the importance of using a jack stand?

You must use jack stands when you work underneath your vehicle. If you don’t, you run the risk of serious injury or even death. People have been crushed to death when vehicles that were improperly secured fell on them. Never jack up a vehicle without blocking the wheels to keep it from rolling.

What are trailer jacks?

Hitch jacks, also known as trailer jacks or tongue jacks, are used to raise and stabilize a trailer so it can be attached to the towing vehicle. It’s one of many hitch accessories used to make the process of towing a little easier. Use the jack to raise the trailer to an elevated position.

Is it OK to jack up a truck by the differential?

So here’s our stance on the debate: don’t jack up your vehicle by the differential unless the manufacturer recommends it. Always use a floor jack to apply lifting force at the OEM recommended points, then place your jack stands appropriately—as close to the jacking point as possible.

Can you jack a truck up by the axle?

Yes, you can jack up the truck anywhere on the axle.

What are the OSHA requirements for Trailer jacks?

OSHA Regulations. OSHA requires that trucks be immobilized during the loading and unloading process to ensure safety of the workers. Standards include setting brakes, setting wheel blocks, and using a jack stand.

When do you need a trailer jack stand?

Trailer Jack Stands , used with wheel chocks, meet OSHA guidelines and make your work environment easier to navigate. Trailer jack stands are designed to level a semi-trailer while preventing the accidental upending of that trailer during loading and unloading. They are used when the trailer is not connected directly to a tractor.

Is it safe to use a trailer stabilizer stand?

An upended trailer can be extremely dangerous for workers, not to mention the damage caused to cargo and the trailer itself. Using a suitable trailer stabilizer jack such as the Vestil SP-TOP-R ensures everyone stays safe on the job. HOF Equipment Company carries a wide array of trailer jack stands.

What is the purpose of a fixed Jack?

UNITED STATES DEPARTMENT OF LABOR. The term “fixed jacks” can be defined as jacks or what is known in the trade as “nose cones,” the purpose of which is to hold one end of a trailer being worked so as to avoid the possibility of such trailer being “up-ended” in the course of vehicles coming in and out of the trailer.