What is an integral flange on a bathtub?

What is an integral flange on a bathtub?

The integral tile flange is a ~3 ⁄4″ acrylic flange molded into the tub at the factory and is available only in a 3-sided flange for a rectangular tub and 2-sided flange for a corner tub. The tile flange is designed to screw to the stud wall and must be pre-drilled at the job site.

What is tub built in flange?

live_wire_oak. A tile flange is necessary for a tub that will be also be used as a shower, so as to be able to redirect the shower spray runoff correctly back in to the tub without moisture damage to the walls. It’s not necessary for a drop in soaking or jetted tub that has a separate shower.

Can you replace an alcove tub with a drop in tub?

Yes, drop in tubs can be installed in an alcove, but they’re more commonly installed in more open spaces, freestanding or jutting out from a wall. Depending on the size of the bathroom, a drop in tub installed in an alcove may provide less space; one may be able to fit a larger tub into another space in the room.

What goes first tub or tile?

The tub is almost always set first because it has to be in place before the wallboard is installed, and the tile is never set before that phase of the construction. And don’t worry about whether a new tub would fit into the space the old one did, because it will NEVER fit without some retiling.

What is the difference between a drop in tub and an alcove tub?

When comparing alcove vs drop-in bathtubs, drop-in tubs offer more flexibility in shape, size and design options. Alcove tubs must fit into a specified space between three walls, while drop-in tubs can fit any space. Also, alcove tubs are less expensive and more easily accessible than drop-in bathtubs.

When should you use a drop in tub?

Drop-in tubs are ideal for people who like sitting and soaking in the bathtub for long periods of time because of the shape. The tub offers you a deeper water level than the alcove tub.

Does tile go over tub flange?

ANSWER – No there should not be a gap between the top of the bathtub flange and the backer board on the wall. Technically, after the tile is installed over the backer board that gap between it and the tub ledge should be filled with an ASTM C920 sealant (caulking e.g. silicone).