What springs do MSD distributors use?

For an MSD distributor, light silver springs provide the quickest rate of advance, while heavy silver springs have the slowest rate of advance. Keep in mind, it’s entirely possible to mix and match springs. For example, you might be able to use one heavy silver and one light silver spring in your combination.

How does a MSD distributor work?

MSD’s ignition boxes feature Multiple Sparks at lower RPMS, along with a stronger, hotter, higher voltage spark to completely ignite the mixture. Each spark an MSD ignition produces is an extremely high current spark. This is because MSD uses Capacitive discharge technology to produce a very high primary voltage.

How do you clean an MSD distributor?

We Recommend Taking A Soft Wire Brush And Knock Off As Much Rust Scale As Possible Then With Compressed Air Blow The Unit Clean. Next You Will Want To Lightly Coat The Inside Of The Dist. With A Non-flamable Rust Inhibitor Spray. To Help Reduce The Rust Build Up Drill About Four 1/4 Inch Holes On The Dist.

What is locking out a distributor?

locked out. or. locked in.. it means that the distributor internal advance mechanism does not change / move the timing… some electronic ignition systems can have a “internal” electrical or electronic mannor that changes (retards) the timing….

Can you bypass a MSD box?

To bypass the MSD, All you need to do is disconnect the car’s coil harness (Dark Green and Yellow , Red and Light Green) from the MSD input wires (Red , White) and plug these (DG/Y and R/LG) right into the new coil. I would also diconnect the (Heavy Red +12 volts) that powers the MSD.

How do you test a MSD distributor?

Magnetic Pickup in the Distributor The magnetic pickup in MSD Distributors can also be checked with an Ohm meter to make sure it is within operating specifications. Once again, connect the Ohm meter’s leads to the two terminals of the pickup. The resistance should be within 400 – 1,300 ohms.

How do you clean a distributor?

Step 4: Use Contact Cleaner- Spray some contact cleaner on the internal contacts of the distributor cap. Step 5: Dry Out- If you have a compressed air source, apply the compressed air through the cap. This will help it to dry faster. You can also use a clean rug and carefully rub it until the cap is completely dry.

How do you replace the magnetic pickup on a MSD distributor?

Magnetic pickup replacement

1. you will have to remove the gear.
2. remove shaft.
3. remove the 4 allen screws.
4. remove the center snap ring.
5. remove the strain relief around the four wires going into the housing.
6. pull pc board up ,,,,now you have access to the bottom leads of the magnetic pick-up.

Do the MSD advance kits work with every MSD distributor?

These MSD advance kits are the same kits that come with your MSD distributor. The kits include the needed components to make your distributor perform like it did when it was brand new. I have an MSD Distributor without vacuum advance on my 351w. i don’t know its part number but i’d like to recurve it. Do this kit work with every MSD distributor?

What are the MSD advance stop bushings for?

Sold as a kit. Includes (6) advance stop bushings for 18, 19, 21, 23, 25 and 28 degrees. Designed for MSD Billet distributors. These MSD advance kits are the same kits that come with your MSD distributor. The kits include the needed components to make your distributor perform like it did when it was brand new.

Can a MSD 8464 curve kit be used?

Oscar, The 8464 curve kit works on MSD Billet distributors. As long as you have a Billet or Pro-Billet distributor this kit will work. 0 of 0 found this answer helpful. Assuming your MSD distributor has a mechanical / centrifugal advance…this kit will work.