Why does my Cabrio dryer say af?

The AF code (Air Flow) on a Cabrio Dryer is signaling that the machine does not have proper airflow. The excessive lint inside the drum shows that the lint is not being drawn into your dryer filter because of the poor circulation of air.

How do you clear the AF code on a dryer?

To clear the code, press STOP once and the estimated time remaining countdown should return to the display. The AF code will continue to appear with each cycle until the low airflow condition is resolved.

Why is my Whirlpool Cabrio dryer not heating up?

Cabrio dryers should be connected to two household fuses or circuit breakers. If one of these trips or fails, the drum will turn, but the dryer may not provide heat. Reset the breaker or replace the fuse and restart your dryer. You should also make sure the dryer is connected to a 240-volt power supply.

How do I reset my Whirlpool Cabrio dryer?

How to Reset a Whirlpool Cabrio

1. Touch any key on the display pad to clear the error code, if applicable, or press “Pause/Cancel.”
2. Choose a new cycle and press “Start” to begin.
3. Turn off and disconnect the Cabrio if the error or problem persists.
4. Wait several minutes before restoring power.

What does F1 mean on a Whirlpool Cabrio dryer?

To recap, the cause of the Whirlpool Cabrio dryer F1 error code is a miscommunication between the control board and the rest of the machine. Check for any loose or damaged wires. If no loose or damaged wires are found, replace the control board and this should clear up your problem.

How do I fix F1 error on Whirlpool oven?

If you receive a two-digit error code reading F1, your Whirlpool range may be experiencing one of three problems. There may be an analog to digital failure; if this is the case, simply disconnect the range for 30 seconds and plug back in. If the same display reappears, you may need to replace the control board.

What to check if dryer is not getting hot?

Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow….“Why Is My Dryer Not Heating?”: The More Complex Answers

1. A faulty thermal fuse.
2. A broken heating element.
3. A broken thermostat.
4. A defective timer motor.
5. A complex electrical or gas issue.

What does AF error mean on Cabrio dryer?

The AF code (Air Flow) on a Cabrio Dryer is signaling that the machine does not have proper airflow . Dryers need to be able to pull in fresh air and expel humidity to be able to dry fabrics.

What does F1 mean on a whirlpool Cabrio dryer?

The “F1” error code prevents the washer from operating and is one of the main failures that occurs with the device. The Whirlpool Cabrio washer features more than 20 different fault codes that address errors with the washer’s multiple functions including electrical problems,…

What does Whirlpool Cabrio F1 error code mean?

Whirlpool Cabrio Washer Error F1. The Cabrio Washer F1 error code happens when the main control board gets a bad signal from the water level pressure switch circuit. This is normally caused by a pinched or ripped water level pressure switch hose. Steps to take to try and remedy this error are listed below.

What does “AF” mean on my dryer?

The dryer display for the time is displaying “AF”. “AF” means there is an air flow problem within the venting system. There is either a restriction in the hose, outside vent cover, the front vent, or maybe the lower blower assist isn’t rotating.