How do I clear ASA configuration?

How to clear an ASA`s configuration

1. Reboot the device.
2. On boot hit `escape` so that you break the normal startup process and enter ROMMON.
3. Change the current confreg so that you can bypass the current startup config sing the command: rommon #1>confreg 0x41.
4. Reset the appliance with the boot command, rommon #2>boot.

How do you set ASA in transparent mode?

Configuration Steps:

1. Change the ASA to Transparent Mode.
2. Enable and configure each physical interface as a part of same bridge-group.
3. Assign an IP address to the Bridge Virtual Interface (BVI) for ASA management.
4. Enable the HTTP Server for ASA Management through ASDM.

How do you remove a firewall?

Reset the Firewall Rules to Default Just open up the Windows Firewall by searching your Start Menu or screen for it (don’t choose the advanced firewall panel), open it up, and then click the Restore defaults item on the left side.

How do you reset ASDM ASA 5506?

The device can be rebooted with one of these methods. For ASA security appliances: CLI – Enter the reload command in privileged mode. ASDM GUI – Choose Tools > System Reload.

What are three characteristics of ASA transparent mode?

What are three characteristics of ASA transparent mode? (Choose three.)

• The interfaces of the ASA separate Layer 3 networks and require IP addresses in different subnets.
• This mode is referred to as a “bump in the wire.”
• This mode does not support VPNs, QoS, or DHCP Relay.
• It is the traditional firewall deployment mode.

What is transparent mode?

Transparent mode converts the firewall device from its default layer 3 route mode to what is essentially a layer 2 bridge. Once all interfaces have been converted to the layer 2 zones, the device is considered to be in transparent mode.

Which is the default configuration for ASA 5510?

ASA 5510 and Higher Default Configuration. The default factory configuration for the ASA 5510 and higher adaptive security appliance configures the following: •The management interface, Management 0/0. If you did not set the IP address in the configure factory-default command, then the IP address and mask are 192.168.1.1 and 255.255.255.0.

How to clear configuration file in Cisco ASA?

Clear configuration file to the basic configuration of ASA. You will get configured DHCP Server configured for INSIDE hosts, all interfaces will be in vlan 1, OUTSIDE interface vlan 2 will be set with command [ip address dhcp setroute], you will get object network, configured with NAT, ACL etc. Something likes plug-and-play for SOHO.

How can I Reset my Cisco ASA to factory defaults?

Once in we can erase the saved config (or just reset the password if you want the config) reset the configuration register to it’s original value, and reboot the appliance – simple! Connect your console cable and make sure you can see the command prompt for the ASA – even if you can’t log in.

Which is Cisco ASA 5505 adaptive security appliance?

The default factory configuration for the ASA 5505 adaptive security appliance configures the following: • An inside VLAN 1 interface that includes the Ethernet 0/1 through 0/7 switch ports. If you did not set the IP address in the configure factory-default command, then the VLAN 1 IP address and mask are 192.168.1.1 and 255.255.255.0.