How do you clear a DSC alarm trouble code?

DSC alarms can go off for a number of reasons. To reset the alarm or the warning lights, enter your master code twice, press the reset button, and then enter “*72” if the alarm is still ringing. Once the alarm is off, try to find out why it went off.

How do I reset my DSC 1616?

Perform the following to default the main control panel:

1. Power down the system completely.
2. Connect a short (wire) between Zone 1 and PGM1 on the control panel (remove all other wires form these terminals).
3. Power up the control panel (AC power only) for 10 full seconds.

How do I find my DSC trouble code?

To view a trouble condition, press [*][2]. The trouble light will flash and the LCD will display the first trouble condition present. Use the arrow keys to scroll through all trouble conditions present. Note: When additional information is available for a specific trouble condition a [*] will appear on the display.

How do I turn off the yellow light on my DSC alarm?

How can I silence the trouble beep on the keypad? Press the ‘#’ key to silence the beeping, however you will need to fix the problem before the light will go out. You can also press ‘9’ after ‘*2’ to acknowledge and cancel the trouble condition but you still must fix the problem.

What is the installer code for DSC?

5555
The default installer code for a DSC is 5555. The installer code is the code that is used to get into the DSC programming mode so you can set the system up and make changes to panel programming. Having the installer code is the most important part of setting up the system.

How do I bypass zone on DSC 1616?

How to Bypass a Zone on a DSC Power Series Security Alarm Panel

1. The System Must be disarmed prior to proceeding.
2. Press the * Key.
3. Press the 1 Key.
4. Use the > key to scroll to the zone you wish to bypass.
5. Press the * Key on the appropriate zone.
6. A “B” should appear next to the zone when the system is bypassed.

How to fix DSC 1616 1832 and 1864?

How do I fix a general system tamper on the DSC 1616, 1832, and 1864 systems? How do I fix a module supervision trouble condition on a DSC 1616, 1832, or 1864? I’m not using a telephone line, how do I turn off telephone line monitoring on the DSC 1616, 1832, and 1864?

How to fix module supervision trouble condition on a DSc 1616?

How do I fix a module supervision trouble condition on a DSC 1616, 1832, or 1864? The first thing to check if you have this trouble condition is that all keypads and modules are still connected and that the wires are intact. If you find any issues there, reconnecting them should clear the trouble condition.

How to acknowledge and check a trouble on DSC power series?

In this tech tip, we’ll look at how to check and acknowledge a trouble on the keypad of a DSC Power Series Alarm Monitoring Panel. This tip is applicable if you use your system at home or for your business or commercial security alarm system. From time to time, conditions may arise which cause what is known as a ‘trouble’ condition on the keypad.

What are the trouble codes for DSC alarms?

Understanding DSC Alarm Trouble Codes. 1 Service Required (press [1] for more information) 1.1 Low Battery (main battery in panel) 1.2 Bell Circuit. 1.3 System Trouble. 1.4 System Tamper. 1.5 Module Supervision. 1.6 RF Jam Detected. 1.7 PC5204 Low Battery. 1.8 PC5204 AC Failure.