How do you replace the pull cord on a snowblower?
How do you replace the pull cord on a snowblower?
How to Replace the Starter Cord on a Snow Blower
- 1) Remove the Start Cord Assembly. Remove the starter cord assembly by taking out the bolts holding it in place.
- 2) Remove the Cord.
- 3) Attach Replacement Cord to Starter Handle.
- 4) Attach Replace Cord to Recoil Pulley.
- 5) Wind the Recoil Pulley.
- Let the Cord Slowly Rewind.
Why will my pull cord not retract?
The recoil spring retracts the rope back into the starter after you pull the rope to start the engine. If the rope does not recoil, the spring needs to be recoiled manually or replaced, depending on the problem with the spring. If the spring is broken it will need to be replaced; if not, the spring can be recoiled.
How do you replace starter on Toro snow blower?
Put the new rope through the shroud and then put the rope into the pulley. Leave about a foot of rope outside of the pulley. Tie a knot at the end of the rope so it won’t go into the pulley. Use a ratchet to loosen the three bolts holding the starter shroud onto the front of the blower’s motor.
What to do if your snow blower starter is broken?
If you are having problems with the starter on your Toro snow blower, you can fix the problem with minimal knowledge of the subject. The pull cord on the snow blower’s motor is used to start the motor and blow the snow away. If your pull cord is broken or damaged, you can fix the problem with a few tools found around your home.
What do you need to know about Toro snowblowers?
Toro is a leading manufacturer of lawn equipment, snowblowers and irrigation systems. Toro snowblowers have been relied upon for decades to help homeowners and businesses clear snow from their properties promptly and efficiency. If your snowblower encounters a problem with its starting mechanism, you cannot use it.
How does a small engine recoil starter work?
Small engine recoil starter assembly. This item includes the pulley and spring. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. Briggs & Stratton starter gear (also called a pinion gear), 16-tooth, plastic.
