What nails do you use for fascia?

It calls for 2-inch, 16-gauge, corrosion-resistant finish nails only when you are attaching fascia to double sub-fascia. Nails should not be closer than 1 1/4 inches from the edges and no nearer than one inch from the ends.

What nails do I use for soffit and fascia?

Use 1 ½” roofing nails to install soffit. Use white panel nails to install aluminum fascia. Use tin snips to cut F-channel, vinyl soffit, and aluminum fascia.

What size should fascia boards be?

Fascias are typically made from 1-inch material, with the width being enough to cover the rafter width. Typically rafters will range from 2×6 to 2×8, although some are larger depending on the roof construction. Therefore, the more common fascia board sizes are 1×6 or 1×8.

Do you need a sub fascia?

Though not required by building codes, the reasons for subfascia have more to do with evening out the rafter tail irregularities, and providing structural support for the roof edge and gutters. Another reason many trim manufacturers include 2x subfascia in their installation details is for gutter support.

Why is my fascia buckling?

This also happens when the underlying wood fascia has a bow in it. Even when you try your best, fascia will usually have some ripples in it. So if it looked good initially and now has a buckle, it’s probably temperature related. The fascia is expanding and getting tight on the nails.

Does fascia go on before soffit?

The job goes smoother when you follow the correct installation sequence. First nail up the J-channel, then soffit panels, then fascia, then drip edge.

Can I use 2×4 for fascia board?

Install 22-1/2″ long 2x4s between the trusses to support the fascia boards where they butt. See detail below. 2.

What is the best material for fascia boards?

Wood has proven to be the most effective board material. When properly implemented with the right roof covering, wood can be quite a resistant and aesthetically pleasing fascia that complements the overall structure.

Is fascia required by code?

Sub-fascias are not required by code. The fascia can be nailed directly to the truss tails, but while the sub-fascia is typically a 2x, t…

Can you use a brad nailer for fascia?

To nail siding, exterior trim, fascia: You need a gun specifically made for nailing ‘siding’. Yes, it is actually classifed as a “siding Nailer”. It uses 2″ to 2 3/4″ length Galvanized nails. You have to use galvanized nails, otherwise they will rust.