How do you program a PetSafe wireless dog collar?

How do I re-synchronize my wireless system?

1. Remove the receiver collar from your pet.
2. Remove the battery from the receiver collar.
3. At the transmitter, move the boundary switch from the low to the high position.
4. Slowly adjust the boundary control dial up to #8, down to #1 and then back to the #4 position.

How do I know if my pet safe collar is working?

If you wish to test the battery:

1. Remove your pet’s receiver collar from your pet.
2. Take the collar to the boundary area of your containment system and listen for the collar to beep.
3. If the collar beeps or the test light tool illuminates, the battery and collar are working.

How do wireless pet containment systems work?

A wireless dog containment system has two parts: the transmitter and the receiver. The transmitter plugs into an electrical outlet, and the wireless dog collar has the receiver. The transmitter sends out a radius of radio frequencies, and you can adjust the signal distance to your desired boundary space.

How do I adjust the Invisible Fence intensity?

Adjust the Power Level After checking the current level, press the button again within 5 seconds to raise the correction level. The collar will beep or blink in series to indicate the new shock level. Press the button again within 5 seconds to raise the level once more.

How do you test a Sportdog collar?

Using the Test Light Tool

1. Turn the Collar Receiver on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will flash.
5. NOTE: At higher stimulation levels, the Test Light will flash brighter.
6. Turn the Collar Receiver off.

Why is petsafe collar blinking red?

Charging too often can reduce battery life. Charge your receiver collar when the receiver indicator light blinks red. The system works by sending a radio signal through a buried wire (boundary wire). Your pet wears a receiver collar that picks up the signal.

How do you set boundaries on PetSafe?

Testing the Boundary

1. Make sure the Receiver Collar Battery is good. Set the Correction Level to 2 or above.
2. Hold the Test Light Contacts to the Contact Points.
3. Walk toward the Boundary Zone holding the Receiver Collar at your pet’s neck level until the Test Light flashes.
4. Save Test Light for future testing.