How do I reset my Weiser smart lock code?

Weiser Lock reset:

1. Remove the battery cover using the Allen key.
2. Remove the battery pack.
3. Press and hold the program button while reinserting the battery pack.
4. Hold the program button for 30 seconds until the status LED flashes red.
5. Press the program button again.

What is the master code for Weiser?

0-0-0-0
The lock is programmed with the default mastercode 0-0-0-0. Replace this with a code of your own. The mastercode must be 4-10 digits. Keep door open and unlocked during programming.

How do I change the code on my Weiser door?

Note: Programming instructions can also be found on interior of lock.

1. a. Press the program button on the interior unit once.
2. b. Enter in 4 to 8 digit code onto the keypad.
3. c. Press the “LOCK” button to save code.
4. d.
5. a. Press the program button on the interior unit twice.
6. b.
7. c.
8. d.

How can I change my smart lock code?

How do I reset a code on my Powerbolt?

1. Insert functioning key & turn 1/4 turn clockwise.
2. Insert & remove the SmartKey learn tool. Remove functioning key.
3. Insert new key & turn 1/2 turn counter-clockwise. Done. Your lock is now re-keyed! “”

How do I change the code on my Weiser SmartCode 5?

Press and HOLD Program button until keypad flashes green (about 5 seconds). Enter new mastercode. Press Lock button once. Re-enter mastercode.

Can Weiser smart keys be copied?

A: SmartKey locks can only be re-keyed if you have the current functioning key and the SmartKey Learn Tool. If someone does not have the current functioning key, then that person will not be able to re-key your locks.

How do you program a Weiser Powerbolt 1?

Make sure the door is open and unlocked. Press PROG -(for 30 seconds). You will hear 1 long beep….Note: Beeper is still active for “low battery” alarms.

1. Press PROG.
2. You will hear 2 long beeps.
3. Press7 8.
4. Press PROG.
5. You will hear 1 beep if successful. If unsuccessful, you will hear 3 short beeps. Repeat from step 1 slowly.

How do I change my Weiser Smartcode 10 code?

Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode.

How do I reset my Weiser SmartCode 10 code?

How do you change the code on a keyless entry lock?

1. Use a Phillips screwdriver to unscrew the four red screws securing the front plate of your keyless door lock to the base.
2. Hold down the “C” button from the front of the faceplate the entire time you are changing the code on your keyless door lock.