How much does it cost to replace injectors on a BMW?
How much does it cost to replace injectors on a BMW?
BMW 328i Fuel Injector Replacement Cost Estimate. Labor costs are estimated between $157 and $198 while parts are priced between $928 and $1,019. This range is based on the number and age of BMW 328i’s on the road.
Can you put fuel injector cleaner in a BMW?
The Sea Foam IC5 Fuel Injector Cleaner is especially great for BMW and almost any type of vehicle. It is easy to pour also concentrated formula treats up to 25 gallons. Also, you do not need to use higher octane fuel.
Can you put too much fuel injector cleaner your car?
What Happens If You Put Too Much Fuel Injector Cleaner? It is possible to give a car too much of a good thing and add too much fuel injector cleaner. If this happens, you can risk damaging the lining of the fuel tank. Also, you may notice that there is lowered engine performance and fuel efficiency.
How long do BMW fuel injectors last?
between 50,000 and 100,000 miles
The fuel injectors on your car will typically last between 50,000 and 100,000 miles. The length of time that the injector lasts has a lot to do with the type of gas that is used in the car and how often the various fuel filters are changed.
What’s the best way to replace an injector?
One is to use compressed air (if you have a compressor), set the compressor to about 30 psi max and give a short burst of pressure inside the front valve (take the cap off, and it will look similar to your tire valve stem – and works the same). Another method is to use a small screwdriver and press the valve – fuel will come out, but not too much.
What happens when you change the injector O-rings?
1.) Over time, the injector O-rings just like almost any rubber, will deform, loose elasticity, change some its properties. Some effects are deteriorated mpg (for some), or fuel leak for others. The lower mpg (I experienced it too) is due air geting sucked in – just like a vacuum leak.
How to take the beauty cover off an injector?
Remove the beauty cover (10mm). You will see the O2 sensors wires, just pull them out from the clip, set them aside, then pull the retaining clip out: Now, you need to take off the long electrical connector box. This is where I had trouble, because the retaining clips are upside down, and very hard to take them off.
How to replace the O2 sensor in a X5?
More 330 had this issue, and lately the X5 with the i6 engine. Remove the beauty cover (10mm). You will see the O2 sensors wires, just pull them out from the clip, set them aside, then pull the retaining clip out: Now, you need to take off the long electrical connector box.
https://www.youtube.com/watch?v=XKmUI2zhdpw
