How do I program my amino remote control?

Press and hold both the 1 and the 3 buttons at the same time on the remote control for approximately 3 seconds until the TV standby button remains lit, then release both buttons. 2. Point the remote control at the TV set and press and hold down the TV Standby button or the Mute button on the remote control.

How do I set up my HTC remote?

Complete the following steps.

1. Turn device on.
2. Press the Device button (TV, DVD, etc.)
3. Press and hold SETUP (the LED will blink twice)
4. Enter 9-9-1 (the LED will blink twice)
5. Designate Device type: Press 1 for TV.
6. Press POWER button.
7. Press CHANNEL UP repeatedly until the device turns off.
8. Press SETUP when device turns off.

How do I configure my amino h150?

How to Configure an Amino Set Top Box IP

1. Turn the power on for the wireless keyboard by pressing the power button in the top-right corner of the keyboard.
2. Turn on the Amino set top box and turn on the TV.
3. Press “ALT”+”M” on the wireless keyboard when the Amino splash page appears on the TV.

How do I sync my entone remote to my TV?

On the remote control, press a device mode key for 5 seconds (i.e., “TV” or “AUX”). The device mode key will light up. NOTE: Use the “AUX” mode key for a VCR, DVD player, cable box, satellite receiver or audio device. Enter the four-digit device code for your device.

What to do when remote is not working?

NOTE: Because each of these steps represents a possible solution, check the function of the remote control after completing each step.

1. Make sure none of the remote buttons are jammed.
2. Reset the remote.
3. Clean the remote control terminals.
4. Replace with fresh batteries.
5. Perform a power reset on the TV.

What is CBL button on remote?

CBL:Cable Set-Top Box ; TV:TV; AUD:AUD. DVD:TV ; AUX:AUX. You have the option of controlling CABLE Volume and Mute through the TV, DVD or AUD.

How do I program my ur5u 9020l remote?

STEP1 Turn on the device you want to program- to program your TV, turn the TV on. STEP2 Point the remote at the TV and press and hold TV key for 3 seconds. While Holding the TV key, the TV LED will light off and on again.

How do I reset my Amino A140?

Insert the USB Stick into the Amino 140. 6. Press the reset button near the USB connector.