Where does an axle seal connect to?
Where does an axle seal connect to?
An axle seal is the part of the vehicle that connects the axle to the rear differential, or the transmission. The purpose of the axle seal is to keep transmission fluid from leaking.
Do you grease an axle seal?
You don’t need to grease the axle bearings. They are sealed and pre greased. The differential bearings could use a little gear oil.
Should oil seals be installed dry?
NEVER EVER replace a seal dry! The outer part of the seal should have a very slight smear of seal or bearing mount made by Threadlock or similar. The internal part of the seal should be lubricated with silicon grease.
What is Dana 30 axle?
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions.
How do you replace a front axle seal?
Axle Seal Replacement:
- Raise the vehicle and remove the wheel.
- Loosen the axle nut.
- Remove the brake caliper, bracket, and rotor.
- Remove the knuckle from the strut.
- Remove axle the knuckle.
- Remove the axle from the transmission.
- Replace the seal.
- Put everything back together.
What to do about inner axle seal on Dana 30?
Great Compatibility — Works on Dana 30, 44 and 60 front differentials. (Please refer to the model in the product description list below the page) Upgrade Design — Designed to safely and evenly apply pressure to the inner axle seal to press it into the axle housing without damaging the seal.
How to install an inner axle side seal?
Take off the bolts to remove the carrier from the axle assembly. NOTE: There are shims in here so make sure that you don’t mess those up. Remove the old inner seals on both sides. Then clean any dirt out the tubes. Put the new seal on the puck. Then place the seal and the tool in the differential and tighten the nut until the seal is in place.
How to get oil out of front axle?
Disassemble the front axle according to the steps listed in the factory service manual and remove the old inner axles seals using a long screwdriver and hammer to knock them out toward the center from the end of the axle tube. 2. Install a new seal onto the seal driver as shown below. The seal is designed to snap into place on the adapter. 3.
How do you replace an axle in Michigan?
MADE IN MICHIGAN USA! 1. Disassemble the front axle according to the steps listed in the factory service manual and remove the old inner axles seals using a long screwdriver and hammer to knock them out toward the center from the end of the axle tube. 2. Install a new seal onto the seal driver as shown below.
